MH3/IPA - Multi-hole Inner Piece Adapter

The Multi-hole Inner Piece Adapter is used in place of a standard
inner piece when no tube is available to clamp around and when a square
frame tube has existing bolt holes for attachment of accessories.

The MH3 part has seven countersunk bolt holes spaced at 1/2" increments
and two rows of seven threaded holes spaced at 1/2" increments. The Inner Piece
Adapter
is attached with bolts into the threaded holes of the adapter after
the component has been installed onto the wheelchair. It is possible to attach
the MH3 part with bolts through the countersunk holes and nuts on the inside of the
wheelchair frame or with 1/4" bolts through the wheelchair frame and threaded into
the threaded holes of the MH3 part.

The overall length of the MH3 is 4". If less than 4" of clear length is available on
the wheelchair frame tube it may be possible to instead use the MH2/IPA.

The MH3/IPA Multi-hole Inner Piece Adapter is used with a TNUT (track nut) to fit
the seat frame track system on some wheelchairs (i.e. Invacare, Pride Mobility & Quantum).

For round tube with bolt holes see the Multi-hole Round Tube Adapter.

[CLOSE WINDOW]