DAEDALUS TECHNOLOGIES, INC.
MAKING TECHNOLOGY MORE ACCESSIBLE
Installing the DAESSY Locking Swing-away Mount - DLSA7
Steps in the Installation Procedure
- Identify the Parts
- Assemble and Install the Locking Frame Clamp Assembly
- Install and adjust the Locking Index Clamp (ICLSA) and Right-angle Tube
- Install the Quick Release Base (TUSB)
- Adjust the Release Cable
Identify the Parts of the DAESSY Locking Swing-away Mount
The standard DAESSY Locking Swing-away Mount consists of the following parts:
| Part Code | Part Name |
| xxxIP | Frame Clamp Inner Piece |
| LSAOP | Locking Swing Away Outer Piece |
| O3L | Offset Link |
| ICLSA | Index Clamp for Locking Swing Away |
| CABLE | Cable Assembly to release the Locking Pin, preinstalled on Right Angle Tube |
| RT22x16* | Right Angle Tube 22 inches vertical by 16 inches horizontal |
| TUSB* | Total Quick Release Base |
The black anodized aluminum components have part codes stamped or engraved into the metal. These should be identified and laid out.
The DAESSY Locking Swing-Away Mount – DLSA7 is usually supplied partially assembled. The Release Cable is attached to the Right Angle Tube; other parts are packed separately. The Pinch Clamps for the Locking Swing-Away Index Clamp (ICLSA) and Total Quick Release Base (TUSB) are installed in their hole and retained by plastic plugs.
The Swivel Clamp for joining the Frame Clamp Inner Piece and Offset Link (O3L) is fastened into the hole in the end of the O3L which is stamped IP and the Swivel Clamp for attaching the Locking Swing-Away Outer Piece (LSAOP) to the other end of the O3L is fastened to the LSAOP.
The size and shape of the Frame Clamp Inner Piece will depend on the type of wheelchair and the attachment location, and may not be exactly as shown in the diagrams. More than one Offset Link (O3L) may be included.
Specific installation instructions may be supplied with components, especially components that vary from the standard parts list. In the case of contradictory instructions, component specific instructions provided with the mounting components will supersede the installation procedures outlined in this document.
Caution:
It is very important that all packaging be thoroughly inspected for loose parts and instruction papers. All the mount components must be identified and checked against the standard parts list, and the order list BEFORE any packaging is thrown away.
[Next Step: Assemble and Install the Frame Clamp Components]
Locking Swing Away Mount