DAEDALUS TECHNOLOGIES, INC.
MAKING TECHNOLOGY MORE ACCESSIBLE
Installing the DAESSY Rear Folding Mount - DRFM6
Final Position Adjustment
When the In-use position of the Horizontal Tube needs further adjustment to obtain the best position for the device this can be achieved by slightly rotating the Rear Folding Adapter around the Swivel Clamp that joins it to the Offset Link or Inner Piece. This method of adjusting the position of the Horizontal Tube will change both the In-use and Folded positions. Rotating the Rear Folding Adapter to raise the In-use position of the Horizontal Tube will lower the Folded position and vice versa.
When the mount is in its final position replace the Screw Cover and Locking Nut.
Check List
Before attaching a device to the Rear Folding Mount check that the following steps in the installation procedure have been completed:
- Bolts on the Frame Clamp Inner Piece fully tight with both bolts tightened evenly.
- Bolts on the Swivel Clamps fully tight; tighten these bolts alternately to get the most effective grip.
- Pinch Clamps tight.
- Screw-on Cover for Stop Pins replaced and screwed down firm with the heads of the Stop Pins in the groove on the inside face of the cover.
- Locking Nut for the Screw-on replaced and screwed into gentle contact with the cover.
For some installations it will be necessary to remove the Rear Folding Adapter to replace the Screw-on Cover and Locking Nut.
Steps in Installation Procedure:
Installation of the DRFM6 has these major steps:
- Identify the Parts
- Install the Frame Clamp Assembly, Rear Folding Adapter and Side Tube
- Install the Elbow Rotate Head, Horizontal Tube and Quick Release Base
- Set the Stop Pins in the Rear Folding Adapter
- Final Adjustments
Rear Folding Mount